From 2b748a0a344847fe6b924407bbe153e1878c9f09 Mon Sep 17 00:00:00 2001 From: Mark Lord Date: Tue, 10 Mar 2009 22:01:17 -0400 Subject: sata_mv: implement IRQ coalescing (v2) Add IRQ coalescing to sata_mv (off by default). This feature can reduce total interrupt overhead for RAID setups in some situations, by deferring the interrupt signal until one or both of: a) a specified io_count (completed SATA commands) is achieved, or b) a specified time interval elapses after an IO completion. For now, module parameters are used to set the irq_coalescing_io_count and irq_coalescing_usecs (timeout) globally. These may eventually be supplemented with sysfs attributes, so that thresholds can be set on-the-fly and on a per-chip (or even per-host_controller) basis. Signed-off-by: Mark Lord Signed-off-by: Jeff Garzik --- drivers/ata/sata_mv.c | 143 +++++++++++++++++++++++++++++++++++++++++++++++--- 1 file changed, 135 insertions(+), 8 deletions(-) (limited to 'drivers/ata') diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c index 206220ec582..ef385451ffd 100644 --- a/drivers/ata/sata_mv.c +++ b/drivers/ata/sata_mv.c @@ -34,10 +34,7 @@ * * --> Develop a low-power-consumption strategy, and implement it. * - * --> [Experiment, low priority] Investigate interrupt coalescing. - * Quite often, especially with PCI Message Signalled Interrupts (MSI), - * the overhead reduced by interrupt mitigation is quite often not - * worth the latency cost. + * --> Add sysfs attributes for per-chip / per-HC IRQ coalescing thresholds. * * --> [Experiment, Marvell value added] Is it possible to use target * mode to cross-connect two Linux boxes with Marvell cards? If so, @@ -67,7 +64,7 @@ #include #define DRV_NAME "sata_mv" -#define DRV_VERSION "1.26" +#define DRV_VERSION "1.27" /* * module options @@ -79,6 +76,16 @@ module_param(msi, int, S_IRUGO); MODULE_PARM_DESC(msi, "Enable use of PCI MSI (0=off, 1=on)"); #endif +static int irq_coalescing_io_count; +module_param(irq_coalescing_io_count, int, S_IRUGO); +MODULE_PARM_DESC(irq_coalescing_io_count, + "IRQ coalescing I/O count threshold (0..255)"); + +static int irq_coalescing_usecs; +module_param(irq_coalescing_usecs, int, S_IRUGO); +MODULE_PARM_DESC(irq_coalescing_usecs, + "IRQ coalescing time threshold in usecs"); + enum { /* BAR's are enumerated in terms of pci_resource_start() terms */ MV_PRIMARY_BAR = 0, /* offset 0x10: memory space */ @@ -88,8 +95,33 @@ enum { MV_MAJOR_REG_AREA_SZ = 0x10000, /* 64KB */ MV_MINOR_REG_AREA_SZ = 0x2000, /* 8KB */ + /* For use with both IRQ coalescing methods ("all ports" or "per-HC" */ + COAL_CLOCKS_PER_USEC = 150, /* for calculating COAL_TIMEs */ + MAX_COAL_TIME_THRESHOLD = ((1 << 24) - 1), /* internal clocks count */ + MAX_COAL_IO_COUNT = 255, /* completed I/O count */ + MV_PCI_REG_BASE = 0, + /* + * Per-chip ("all ports") interrupt coalescing feature. + * This is only for GEN_II / GEN_IIE hardware. + * + * Coalescing defers the interrupt until either the IO_THRESHOLD + * (count of completed I/Os) is met, or the TIME_THRESHOLD is met. + */ + MV_COAL_REG_BASE = 0x18000, + MV_IRQ_COAL_CAUSE = (MV_COAL_REG_BASE + 0x08), + ALL_PORTS_COAL_IRQ = (1 << 4), /* all ports irq event */ + + MV_IRQ_COAL_IO_THRESHOLD = (MV_COAL_REG_BASE + 0xcc), + MV_IRQ_COAL_TIME_THRESHOLD = (MV_COAL_REG_BASE + 0xd0), + + /* + * Registers for the (unused here) transaction coalescing feature: + */ + MV_TRAN_COAL_CAUSE_LO = (MV_COAL_REG_BASE + 0x88), + MV_TRAN_COAL_CAUSE_HI = (MV_COAL_REG_BASE + 0x8c), + MV_SATAHC0_REG_BASE = 0x20000, MV_FLASH_CTL_OFS = 0x1046c, MV_GPIO_PORT_CTL_OFS = 0x104f0, @@ -186,6 +218,8 @@ enum { DONE_IRQ = (1 << 1), /* shift by (2 * port #) */ HC0_IRQ_PEND = 0x1ff, /* bits 0-8 = HC0's ports */ HC_SHIFT = 9, /* bits 9-17 = HC1's ports */ + DONE_IRQ_0_3 = 0x000000aa, /* DONE_IRQ ports 0,1,2,3 */ + DONE_IRQ_4_7 = (DONE_IRQ_0_3 << HC_SHIFT), /* 4,5,6,7 */ PCI_ERR = (1 << 18), TRAN_COAL_LO_DONE = (1 << 19), /* transaction coalescing */ TRAN_COAL_HI_DONE = (1 << 20), /* transaction coalescing */ @@ -207,6 +241,16 @@ enum { HC_COAL_IRQ = (1 << 4), /* IRQ coalescing */ DEV_IRQ = (1 << 8), /* shift by port # */ + /* + * Per-HC (Host-Controller) interrupt coalescing feature. + * This is present on all chip generations. + * + * Coalescing defers the interrupt until either the IO_THRESHOLD + * (count of completed I/Os) is met, or the TIME_THRESHOLD is met. + */ + HC_IRQ_COAL_IO_THRESHOLD_OFS = 0x000c, + HC_IRQ_COAL_TIME_THRESHOLD_OFS = 0x0010, + /* Shadow block registers */ SHD_BLK_OFS = 0x100, SHD_CTL_AST_OFS = 0x20, /* ofs from SHD_BLK_OFS */ @@ -897,6 +941,23 @@ static void mv_set_edma_ptrs(void __iomem *port_mmio, port_mmio + EDMA_RSP_Q_OUT_PTR_OFS); } +static void mv_write_main_irq_mask(u32 mask, struct mv_host_priv *hpriv) +{ + /* + * When writing to the main_irq_mask in hardware, + * we must ensure exclusivity between the interrupt coalescing bits + * and the corresponding individual port DONE_IRQ bits. + * + * Note that this register is really an "IRQ enable" register, + * not an "IRQ mask" register as Marvell's naming might suggest. + */ + if (mask & (ALL_PORTS_COAL_DONE | PORTS_0_3_COAL_DONE)) + mask &= ~DONE_IRQ_0_3; + if (mask & (ALL_PORTS_COAL_DONE | PORTS_4_7_COAL_DONE)) + mask &= ~DONE_IRQ_4_7; + writelfl(mask, hpriv->main_irq_mask_addr); +} + static void mv_set_main_irq_mask(struct ata_host *host, u32 disable_bits, u32 enable_bits) { @@ -907,7 +968,7 @@ static void mv_set_main_irq_mask(struct ata_host *host, new_mask = (old_mask & ~disable_bits) | enable_bits; if (new_mask != old_mask) { hpriv->main_irq_mask = new_mask; - writelfl(new_mask, hpriv->main_irq_mask_addr); + mv_write_main_irq_mask(new_mask, hpriv); } } @@ -948,6 +1009,64 @@ static void mv_clear_and_enable_port_irqs(struct ata_port *ap, mv_enable_port_irqs(ap, port_irqs); } +static void mv_set_irq_coalescing(struct ata_host *host, + unsigned int count, unsigned int usecs) +{ + struct mv_host_priv *hpriv = host->private_data; + void __iomem *mmio = hpriv->base, *hc_mmio; + u32 coal_enable = 0; + unsigned long flags; + unsigned int clks; + const u32 coal_disable = PORTS_0_3_COAL_DONE | PORTS_4_7_COAL_DONE | + ALL_PORTS_COAL_DONE; + + /* Disable IRQ coalescing if either threshold is zero */ + if (!usecs || !count) { + clks = count = 0; + } else { + /* Respect maximum limits of the hardware */ + clks = usecs * COAL_CLOCKS_PER_USEC; + if (clks > MAX_COAL_TIME_THRESHOLD) + clks = MAX_COAL_TIME_THRESHOLD; + if (count > MAX_COAL_IO_COUNT) + count = MAX_COAL_IO_COUNT; + } + + spin_lock_irqsave(&host->lock, flags); + +#if 0 /* disabled pending functional clarification from Marvell */ + if (!IS_GEN_I(hpriv)) { + /* + * GEN_II/GEN_IIE: global thresholds for the entire chip. + */ + writel(clks, mmio + MV_IRQ_COAL_TIME_THRESHOLD); + writel(count, mmio + MV_IRQ_COAL_IO_THRESHOLD); + /* clear leftover coal IRQ bit */ + writelfl(~ALL_PORTS_COAL_IRQ, mmio + MV_IRQ_COAL_CAUSE); + clks = count = 0; /* so as to clear the alternate regs below */ + coal_enable = ALL_PORTS_COAL_DONE; + } +#endif + /* + * All chips: independent thresholds for each HC on the chip. + */ + hc_mmio = mv_hc_base_from_port(mmio, 0); + writel(clks, hc_mmio + HC_IRQ_COAL_TIME_THRESHOLD_OFS); + writel(count, hc_mmio + HC_IRQ_COAL_IO_THRESHOLD_OFS); + coal_enable |= PORTS_0_3_COAL_DONE; + if (hpriv->n_ports > 4) { + hc_mmio = mv_hc_base_from_port(mmio, MV_PORTS_PER_HC); + writel(clks, hc_mmio + HC_IRQ_COAL_TIME_THRESHOLD_OFS); + writel(count, hc_mmio + HC_IRQ_COAL_IO_THRESHOLD_OFS); + coal_enable |= PORTS_4_7_COAL_DONE; + } + if (!count) + coal_enable = 0; + mv_set_main_irq_mask(host, coal_disable, coal_enable); + + spin_unlock_irqrestore(&host->lock, flags); +} + /** * mv_start_edma - Enable eDMA engine * @base: port base address @@ -2500,6 +2619,10 @@ static int mv_host_intr(struct ata_host *host, u32 main_irq_cause) void __iomem *mmio = hpriv->base, *hc_mmio; unsigned int handled = 0, port; + /* If asserted, clear the "all ports" IRQ coalescing bit */ + if (main_irq_cause & ALL_PORTS_COAL_DONE) + writel(~ALL_PORTS_COAL_IRQ, mmio + MV_IRQ_COAL_CAUSE); + for (port = 0; port < hpriv->n_ports; port++) { struct ata_port *ap = host->ports[port]; unsigned int p, shift, hardport, port_cause; @@ -2532,6 +2655,8 @@ static int mv_host_intr(struct ata_host *host, u32 main_irq_cause) * to ack (only) those ports via hc_irq_cause. */ ack_irqs = 0; + if (hc_cause & PORTS_0_3_COAL_DONE) + ack_irqs = HC_COAL_IRQ; for (p = 0; p < MV_PORTS_PER_HC; ++p) { if ((port + p) >= hpriv->n_ports) break; @@ -2620,7 +2745,7 @@ static irqreturn_t mv_interrupt(int irq, void *dev_instance) /* for MSI: block new interrupts while in here */ if (using_msi) - writel(0, hpriv->main_irq_mask_addr); + mv_write_main_irq_mask(0, hpriv); main_irq_cause = readl(hpriv->main_irq_cause_addr); pending_irqs = main_irq_cause & hpriv->main_irq_mask; @@ -2637,7 +2762,7 @@ static irqreturn_t mv_interrupt(int irq, void *dev_instance) /* for MSI: unmask; interrupt cause bits will retrigger now */ if (using_msi) - writel(hpriv->main_irq_mask, hpriv->main_irq_mask_addr); + mv_write_main_irq_mask(hpriv->main_irq_mask, hpriv); spin_unlock(&host->lock); @@ -3546,6 +3671,8 @@ static int mv_init_host(struct ata_host *host, unsigned int board_idx) * The per-port interrupts get done later as ports are set up. */ mv_set_main_irq_mask(host, 0, PCI_ERR); + mv_set_irq_coalescing(host, irq_coalescing_io_count, + irq_coalescing_usecs); done: return rc; } -- cgit v1.2.3