aboutsummaryrefslogtreecommitdiff
diff options
context:
space:
mode:
authorMark A. Greer <mgreer@mvista.com>2009-04-15 12:41:54 -0700
committerKevin Hilman <khilman@deeprootsystems.com>2009-05-28 15:17:48 -0700
commit3abd5acfff0111809463bcfd7236a1bdf09e4e2d (patch)
tree19d2577a3b8dac0b15103baf32a5e2a7b9dc8c1b
parent0b0c4c2a6974eae7b96066cb0da35b526fe58468 (diff)
davinci: Add compare register support to timer code
The Timer64p timer has 8 compare registers that can be used to generate interrupts when the timer value matches the compare reg's value. They do not disturb the timer itself. This can be useful when there is only one timer available for both clock events and clocksource. When enabled, the clocksource remains a continuous 32-bit counter but the clock event will no longer support periodic interrupts. Instead only oneshot timers will be supported and implemented by setting the compare register to the current timer value plus the period that the clock event subsystem is requesting. Compare registers support is enabled automatically when the following conditions are met: 1) The same timer is being used for clock events and clocksource. 2) The timer is the bottom half (32 bits) of the 64-bit timer (hardware limitation). 3) The the compare register offset and irq are not zero. Since the timer is always running, there is a hardware race in timer32_config() between reading the current timer value, and adding the period to the current timer value and writing the compare register. Testing on a da830 evm board with the timer clocked at 24 MHz and the processor clocked at 300 MHz, showed the number of counter ticks to do this ranged from 20-53 (~1-2.2 usecs) but usually around 41 ticks. This includes some artifacts from collecting the information. So, the minimum period should be at least 5 usecs to be safe. There is also an non-critical lower limit that the period should be since there is no point in setting an event that is much shorter than the time it takes to set the event, and get & handle the timer interrupt for that event. There can also be all sorts of delays from activities occuring elsewhere in the system (including hardware activitis like cache & TLB management). These are virtually impossible to quantify so a minimum period of 50 usecs was chosen. That will certianly be enough to avoid the actual hardware race but hopefully not large enough to cause unreasonably course-grained timers. Signed-off-by: Mark A. Greer <mgreer@mvista.com> Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
-rw-r--r--arch/arm/mach-davinci/include/mach/common.h2
-rw-r--r--arch/arm/mach-davinci/time.c141
2 files changed, 105 insertions, 38 deletions
diff --git a/arch/arm/mach-davinci/include/mach/common.h b/arch/arm/mach-davinci/include/mach/common.h
index 22db6774487..715528f0dbd 100644
--- a/arch/arm/mach-davinci/include/mach/common.h
+++ b/arch/arm/mach-davinci/include/mach/common.h
@@ -30,6 +30,8 @@ struct davinci_timer_instance {
void __iomem *base;
u32 bottom_irq;
u32 top_irq;
+ unsigned long cmp_off;
+ unsigned int cmp_irq;
};
struct davinci_timer_info {
diff --git a/arch/arm/mach-davinci/time.c b/arch/arm/mach-davinci/time.c
index f80ae25a52e..fc90d3ee0eb 100644
--- a/arch/arm/mach-davinci/time.c
+++ b/arch/arm/mach-davinci/time.c
@@ -46,14 +46,24 @@ enum {
};
/* Timer register offsets */
-#define PID12 0x0
-#define TIM12 0x10
-#define TIM34 0x14
-#define PRD12 0x18
-#define PRD34 0x1c
-#define TCR 0x20
-#define TGCR 0x24
-#define WDTCR 0x28
+#define PID12 0x0
+#define TIM12 0x10
+#define TIM34 0x14
+#define PRD12 0x18
+#define PRD34 0x1c
+#define TCR 0x20
+#define TGCR 0x24
+#define WDTCR 0x28
+
+/* Offsets of the 8 compare registers */
+#define CMP12_0 0x60
+#define CMP12_1 0x64
+#define CMP12_2 0x68
+#define CMP12_3 0x6c
+#define CMP12_4 0x70
+#define CMP12_5 0x74
+#define CMP12_6 0x78
+#define CMP12_7 0x7c
/* Timer register bitfields */
#define TCR_ENAMODE_DISABLE 0x0
@@ -85,6 +95,7 @@ struct timer_s {
unsigned int id;
unsigned long period;
unsigned long opts;
+ unsigned long flags;
void __iomem *base;
unsigned long tim_off;
unsigned long prd_off;
@@ -94,9 +105,13 @@ struct timer_s {
static struct timer_s timers[];
/* values for 'opts' field of struct timer_s */
-#define TIMER_OPTS_DISABLED 0x00
-#define TIMER_OPTS_ONESHOT 0x01
-#define TIMER_OPTS_PERIODIC 0x02
+#define TIMER_OPTS_DISABLED 0x01
+#define TIMER_OPTS_ONESHOT 0x02
+#define TIMER_OPTS_PERIODIC 0x04
+#define TIMER_OPTS_STATE_MASK 0x07
+
+#define TIMER_OPTS_USE_COMPARE 0x80000000
+#define USING_COMPARE(t) ((t)->opts & TIMER_OPTS_USE_COMPARE)
static char *id_to_name[] = {
[T0_BOT] = "timer0_0",
@@ -107,24 +122,41 @@ static char *id_to_name[] = {
static int timer32_config(struct timer_s *t)
{
- u32 tcr = __raw_readl(t->base + TCR);
-
- /* disable timer */
- tcr &= ~(TCR_ENAMODE_MASK << t->enamode_shift);
- __raw_writel(tcr, t->base + TCR);
-
- /* reset counter to zero, set new period */
- __raw_writel(0, t->base + t->tim_off);
- __raw_writel(t->period, t->base + t->prd_off);
-
- /* Set enable mode */
- if (t->opts & TIMER_OPTS_ONESHOT) {
- tcr |= TCR_ENAMODE_ONESHOT << t->enamode_shift;
- } else if (t->opts & TIMER_OPTS_PERIODIC) {
- tcr |= TCR_ENAMODE_PERIODIC << t->enamode_shift;
+ u32 tcr;
+ struct davinci_soc_info *soc_info = davinci_get_soc_info();
+
+ if (USING_COMPARE(t)) {
+ struct davinci_timer_instance *dtip =
+ soc_info->timer_info->timers;
+ int event_timer = ID_TO_TIMER(timers[TID_CLOCKEVENT].id);
+
+ /*
+ * Next interrupt should be the current time reg value plus
+ * the new period (using 32-bit unsigned addition/wrapping
+ * to 0 on overflow). This assumes that the clocksource
+ * is setup to count to 2^32-1 before wrapping around to 0.
+ */
+ __raw_writel(__raw_readl(t->base + t->tim_off) + t->period,
+ t->base + dtip[event_timer].cmp_off);
+ } else {
+ tcr = __raw_readl(t->base + TCR);
+
+ /* disable timer */
+ tcr &= ~(TCR_ENAMODE_MASK << t->enamode_shift);
+ __raw_writel(tcr, t->base + TCR);
+
+ /* reset counter to zero, set new period */
+ __raw_writel(0, t->base + t->tim_off);
+ __raw_writel(t->period, t->base + t->prd_off);
+
+ /* Set enable mode */
+ if (t->opts & TIMER_OPTS_ONESHOT)
+ tcr |= TCR_ENAMODE_ONESHOT << t->enamode_shift;
+ else if (t->opts & TIMER_OPTS_PERIODIC)
+ tcr |= TCR_ENAMODE_PERIODIC << t->enamode_shift;
+
+ __raw_writel(tcr, t->base + TCR);
}
-
- __raw_writel(tcr, t->base + TCR);
return 0;
}
@@ -222,8 +254,11 @@ static void __init timer_init(void)
/* Register interrupt */
t->irqaction.name = t->name;
t->irqaction.dev_id = (void *)t;
- if (t->irqaction.handler != NULL)
+
+ if (t->irqaction.handler != NULL) {
+ irq = USING_COMPARE(t) ? dtip[i].cmp_irq : irq;
setup_irq(irq, &t->irqaction);
+ }
timer32_config(&timers[i]);
}
@@ -268,15 +303,18 @@ static void davinci_set_mode(enum clock_event_mode mode,
switch (mode) {
case CLOCK_EVT_MODE_PERIODIC:
t->period = davinci_clock_tick_rate / (HZ);
- t->opts = TIMER_OPTS_PERIODIC;
+ t->opts &= ~TIMER_OPTS_STATE_MASK;
+ t->opts |= TIMER_OPTS_PERIODIC;
timer32_config(t);
break;
case CLOCK_EVT_MODE_ONESHOT:
- t->opts = TIMER_OPTS_ONESHOT;
+ t->opts &= ~TIMER_OPTS_STATE_MASK;
+ t->opts |= TIMER_OPTS_ONESHOT;
break;
case CLOCK_EVT_MODE_UNUSED:
case CLOCK_EVT_MODE_SHUTDOWN:
- t->opts = TIMER_OPTS_DISABLED;
+ t->opts &= ~TIMER_OPTS_STATE_MASK;
+ t->opts |= TIMER_OPTS_DISABLED;
break;
case CLOCK_EVT_MODE_RESUME:
break;
@@ -295,12 +333,40 @@ static void __init davinci_timer_init(void)
{
struct clk *timer_clk;
struct davinci_soc_info *soc_info = &davinci_soc_info;
-
+ unsigned int clockevent_id;
+ unsigned int clocksource_id;
static char err[] __initdata = KERN_ERR
"%s: can't register clocksource!\n";
- timers[TID_CLOCKEVENT].id = soc_info->timer_info->clockevent_id;
- timers[TID_CLOCKSOURCE].id = soc_info->timer_info->clocksource_id;
+ clockevent_id = soc_info->timer_info->clockevent_id;
+ clocksource_id = soc_info->timer_info->clocksource_id;
+
+ timers[TID_CLOCKEVENT].id = clockevent_id;
+ timers[TID_CLOCKSOURCE].id = clocksource_id;
+
+ /*
+ * If using same timer for both clock events & clocksource,
+ * a compare register must be used to generate an event interrupt.
+ * This is equivalent to a oneshot timer only (not periodic).
+ */
+ if (clockevent_id == clocksource_id) {
+ struct davinci_timer_instance *dtip =
+ soc_info->timer_info->timers;
+ int event_timer = ID_TO_TIMER(clockevent_id);
+
+ /* Only bottom timers can use compare regs */
+ if (IS_TIMER_TOP(clockevent_id))
+ pr_warning("davinci_timer_init: Invalid use"
+ " of system timers. Results unpredictable.\n");
+ else if ((dtip[event_timer].cmp_off == 0)
+ || (dtip[event_timer].cmp_irq == 0))
+ pr_warning("davinci_timer_init: Invalid timer instance"
+ " setup. Results unpredictable.\n");
+ else {
+ timers[TID_CLOCKEVENT].opts |= TIMER_OPTS_USE_COMPARE;
+ clockevent_davinci.features = CLOCK_EVT_FEAT_ONESHOT;
+ }
+ }
/* init timer hw */
timer_init();
@@ -312,7 +378,7 @@ static void __init davinci_timer_init(void)
davinci_clock_tick_rate = clk_get_rate(timer_clk);
/* setup clocksource */
- clocksource_davinci.name = id_to_name[timers[TID_CLOCKSOURCE].id];
+ clocksource_davinci.name = id_to_name[clocksource_id];
clocksource_davinci.mult =
clocksource_khz2mult(davinci_clock_tick_rate/1000,
clocksource_davinci.shift);
@@ -325,8 +391,7 @@ static void __init davinci_timer_init(void)
clockevent_davinci.shift);
clockevent_davinci.max_delta_ns =
clockevent_delta2ns(0xfffffffe, &clockevent_davinci);
- clockevent_davinci.min_delta_ns =
- clockevent_delta2ns(1, &clockevent_davinci);
+ clockevent_davinci.min_delta_ns = 50000; /* 50 usec */
clockevent_davinci.cpumask = cpumask_of(0);
clockevents_register_device(&clockevent_davinci);