diff options
| author | Felix Fietkau <nbd@openwrt.org> | 2008-11-03 11:27:38 +0100 |
|---|---|---|
| committer | John W. Linville <linville@tuxdriver.com> | 2008-11-21 11:06:05 -0500 |
| commit | 8b0162a3dc5c30e862b7a73da29e32de3170f5e4 (patch) | |
| tree | b37b7930eb666f65a8844e769cc6f861c84c9639 /drivers | |
| parent | 6d64360ac56cda95243f15738a06f2a123c663e5 (diff) | |
ath5k: ignore the return value of ath5k_hw_noise_floor_calibration
Noise floor calibration occasionally fails on Atheros hardware.
This is not fatal and can happen if there's simply too much
noise on the air. Ignoring the calibration error is the right
thing to do here, because when the error is ignored, the hardware
will still work, whereas if the error causes the driver to bail out
of a bigger configuration function and does not configure the tx
queues or the IMR (as is the case in reset.c), the hw no longer
works properly until the next reset.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/net/wireless/ath5k/phy.c | 4 | ||||
| -rw-r--r-- | drivers/net/wireless/ath5k/reset.c | 4 |
2 files changed, 2 insertions, 6 deletions
diff --git a/drivers/net/wireless/ath5k/phy.c b/drivers/net/wireless/ath5k/phy.c index 69625bf4d11..7ba18e09463 100644 --- a/drivers/net/wireless/ath5k/phy.c +++ b/drivers/net/wireless/ath5k/phy.c @@ -2196,9 +2196,7 @@ static int ath5k_hw_rf5110_calibrate(struct ath5k_hw *ah, return ret; } - ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq); - if (ret) - return ret; + ath5k_hw_noise_floor_calibration(ah, channel->center_freq); /* * Re-enable RX/TX and beacons diff --git a/drivers/net/wireless/ath5k/reset.c b/drivers/net/wireless/ath5k/reset.c index b51bc030da0..5003263c9ea 100644 --- a/drivers/net/wireless/ath5k/reset.c +++ b/drivers/net/wireless/ath5k/reset.c @@ -842,9 +842,7 @@ int ath5k_hw_reset(struct ath5k_hw *ah, enum nl80211_iftype op_mode, * * XXX: Find an interval that's OK for all cards... */ - ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq); - if (ret) - return ret; + ath5k_hw_noise_floor_calibration(ah, channel->center_freq); /* * Reset queues and start beacon timers at the end of the reset routine |