Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1750 commits)
  ixgbe: Allow Priority Flow Control settings to survive a device reset
  net: core: remove unneeded include in net/core/utils.c.
  e1000e: update version number
  e1000e: fix close interrupt race
  e1000e: fix loss of multicast packets
  e1000e: commonize tx cleanup routine to match e1000 & igb
  netfilter: fix nf_logger name in ebt_ulog.
  netfilter: fix warning in ebt_ulog init function.
  netfilter: fix warning about invalid const usage
  e1000: fix close race with interrupt
  e1000: cleanup clean_tx_irq routine so that it completely cleans ring
  e1000: fix tx hang detect logic and address dma mapping issues
  bridge: bad error handling when adding invalid ether address
  bonding: select current active slave when enslaving device for mode tlb and alb
  gianfar: reallocate skb when headroom is not enough for fcb
  Bump release date to 25Mar2009 and version to 0.22
  r6040: Fix second PHY address
  qeth: fix wait_event_timeout handling
  qeth: check for completion of a running recovery
  qeth: unregister MAC addresses during recovery.
  ...

Manually fixed up conflicts in:
	drivers/infiniband/hw/cxgb3/cxio_hal.h
	drivers/infiniband/hw/nes/nes_nic.c

1 files changed, 32 insertions, 0 deletions

diff --git a/include/linux/spi/libertas_spi.h b/include/linux/spi/libertas_spi.h
new file mode 100644
index 00000000000..79506f5f9e6
--- /dev/null
+++ b/include/linux/spi/libertas_spi.h
@@ -0,0 +1,32 @@
+/*
+ * board-specific data for the libertas_spi driver.
+ *
+ * Copyright 2008 Analog Devices Inc.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or (at
+ * your option) any later version.
+ */
+#ifndef _LIBERTAS_SPI_H_
+#define _LIBERTAS_SPI_H_
+
+struct spi_device;
+
+struct libertas_spi_platform_data {
+	/* There are two ways to read data from the WLAN module's SPI
+	 * interface. Setting 0 or 1 here controls which one is used.
+	 *
+	 * Usually you want to set use_dummy_writes = 1.
+	 * However, if that doesn't work or if you are using a slow SPI clock
+	 * speed, you may want to use 0 here. */
+	u16 use_dummy_writes;
+
+	/* GPIO number to use as chip select */
+	u16 gpio_cs;
+
+	/* Board specific setup/teardown */
+	int (*setup)(struct spi_device *spi);
+	int (*teardown)(struct spi_device *spi);
+};
+#endif