[Bluetooth] Enforce correct authentication requirements

With the introduction of Security Mode 4 and Simple Pairing from the
Bluetooth 2.1 specification it became mandatory that the initiator
requires authentication and encryption before any L2CAP channel can
be established. The only exception here is PSM 1 for the service
discovery protocol (SDP). It is meant to be used without any encryption
since it contains only public information. This is how Bluetooth 2.0
and before handle connections on PSM 1.

For Bluetooth 2.1 devices the pairing procedure differentiates between
no bonding, general bonding and dedicated bonding. The L2CAP layer
wrongly uses always general bonding when creating new connections, but it
should not do this for SDP connections. In this case the authentication
requirement should be no bonding and the just-works model should be used,
but in case of non-SDP connection it is required to use general bonding.

If the new connection requires man-in-the-middle (MITM) protection, it
also first wrongly creates an unauthenticated link key and then later on
requests an upgrade to an authenticated link key to provide full MITM
protection. With Simple Pairing the link key generation is an expensive
operation (compared to Bluetooth 2.0 and before) and doing this twice
during a connection setup causes a noticeable delay when establishing
a new connection. This should be avoided to not regress from the expected
Bluetooth 2.0 connection times. The authentication requirements are known
up-front and so enforce them.

To fulfill these requirements the hci_connect() function has been extended
with an authentication requirement parameter that will be stored inside
the connection information and can be retrieved by userspace at any
time. This allows the correct IO capabilities exchange and results in
the expected behavior.

Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

1 files changed, 1 insertions, 1 deletions

diff --git a/net/bluetooth/sco.c b/net/bluetooth/sco.c
index a16011fedc1..0cc91e6da76 100644
--- a/net/bluetooth/sco.c
+++ b/net/bluetooth/sco.c
@@ -200,7 +200,7 @@ static int sco_connect(struct sock *sk)
 	else
 		type = SCO_LINK;
 
-	hcon = hci_connect(hdev, type, dst);
+	hcon = hci_connect(hdev, type, dst, HCI_AT_NO_BONDING);
 	if (!hcon)
 		goto done;