aboutsummaryrefslogtreecommitdiff
diff options
context:
space:
mode:
Diffstat
-rw-r--r--arch/i386/pci/fixup.c46
-rw-r--r--drivers/pci/probe.c27
-rw-r--r--drivers/pci/quirks.c59
3 files changed, 30 insertions, 102 deletions
diff --git a/arch/i386/pci/fixup.c b/arch/i386/pci/fixup.c
index c1949ff38d6..cde1170b01a 100644
--- a/arch/i386/pci/fixup.c
+++ b/arch/i386/pci/fixup.c
@@ -74,52 +74,6 @@ static void __devinit pci_fixup_ncr53c810(struct pci_dev *d)
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_NCR, PCI_DEVICE_ID_NCR_53C810, pci_fixup_ncr53c810);
-static void __devinit pci_fixup_ide_bases(struct pci_dev *d)
-{
- int i;
-
- /*
- * PCI IDE controllers use non-standard I/O port decoding, respect it.
- */
- if ((d->class >> 8) != PCI_CLASS_STORAGE_IDE)
- return;
- DBG("PCI: IDE base address fixup for %s\n", pci_name(d));
- for(i=0; i<4; i++) {
- struct resource *r = &d->resource[i];
- if ((r->start & ~0x80) == 0x374) {
- r->start |= 2;
- r->end = r->start;
- }
- }
-}
-DECLARE_PCI_FIXUP_HEADER(PCI_ANY_ID, PCI_ANY_ID, pci_fixup_ide_bases);
-
-static void __devinit pci_fixup_ide_trash(struct pci_dev *d)
-{
- int i;
-
- /*
- * Runs the fixup only for the first IDE controller
- * (Shai Fultheim - shai@ftcon.com)
- */
- static int called = 0;
- if (called)
- return;
- called = 1;
-
- /*
- * There exist PCI IDE controllers which have utter garbage
- * in first four base registers. Ignore that.
- */
- DBG("PCI: IDE base address trash cleared for %s\n", pci_name(d));
- for(i=0; i<4; i++)
- d->resource[i].start = d->resource[i].end = d->resource[i].flags = 0;
-}
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_SI, PCI_DEVICE_ID_SI_5513, pci_fixup_ide_trash);
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, pci_fixup_ide_trash);
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_11, pci_fixup_ide_trash);
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801DB_9, pci_fixup_ide_trash);
-
static void __devinit pci_fixup_latency(struct pci_dev *d)
{
/*
diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
index e159d660449..0eeac60042b 100644
--- a/drivers/pci/probe.c
+++ b/drivers/pci/probe.c
@@ -679,6 +679,33 @@ static int pci_setup_device(struct pci_dev * dev)
pci_read_bases(dev, 6, PCI_ROM_ADDRESS);
pci_read_config_word(dev, PCI_SUBSYSTEM_VENDOR_ID, &dev->subsystem_vendor);
pci_read_config_word(dev, PCI_SUBSYSTEM_ID, &dev->subsystem_device);
+
+ /*
+ * Do the ugly legacy mode stuff here rather than broken chip
+ * quirk code. Legacy mode ATA controllers have fixed
+ * addresses. These are not always echoed in BAR0-3, and
+ * BAR0-3 in a few cases contain junk!
+ */
+ if (class == PCI_CLASS_STORAGE_IDE) {
+ u8 progif;
+ pci_read_config_byte(dev, PCI_CLASS_PROG, &progif);
+ if ((progif & 1) == 0) {
+ dev->resource[0].start = 0x1F0;
+ dev->resource[0].end = 0x1F7;
+ dev->resource[0].flags = IORESOURCE_IO;
+ dev->resource[1].start = 0x3F6;
+ dev->resource[1].end = 0x3F6;
+ dev->resource[1].flags = IORESOURCE_IO;
+ }
+ if ((progif & 4) == 0) {
+ dev->resource[2].start = 0x170;
+ dev->resource[2].end = 0x177;
+ dev->resource[2].flags = IORESOURCE_IO;
+ dev->resource[3].start = 0x376;
+ dev->resource[3].end = 0x376;
+ dev->resource[3].flags = IORESOURCE_IO;
+ }
+ }
break;
case PCI_HEADER_TYPE_BRIDGE: /* bridge header */
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index 5b448381169..9ca9b9bf616 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -797,56 +797,6 @@ static void __init quirk_mediagx_master(struct pci_dev *dev)
DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_PCI_MASTER, quirk_mediagx_master );
/*
- * As per PCI spec, ignore base address registers 0-3 of the IDE controllers
- * running in Compatible mode (bits 0 and 2 in the ProgIf for primary and
- * secondary channels respectively). If the device reports Compatible mode
- * but does use BAR0-3 for address decoding, we assume that firmware has
- * programmed these BARs with standard values (0x1f0,0x3f4 and 0x170,0x374).
- * Exceptions (if they exist) must be handled in chip/architecture specific
- * fixups.
- *
- * Note: for non x86 people. You may need an arch specific quirk to handle
- * moving IDE devices to native mode as well. Some plug in card devices power
- * up in compatible mode and assume the BIOS will adjust them.
- *
- * Q: should we load the 0x1f0,0x3f4 into the registers or zap them as
- * we do now ? We don't want is pci_enable_device to come along
- * and assign new resources. Both approaches work for that.
- */
-static void __devinit quirk_ide_bases(struct pci_dev *dev)
-{
- struct resource *res;
- int first_bar = 2, last_bar = 0;
-
- if ((dev->class >> 8) != PCI_CLASS_STORAGE_IDE)
- return;
-
- res = &dev->resource[0];
-
- /* primary channel: ProgIf bit 0, BAR0, BAR1 */
- if (!(dev->class & 1) && (res[0].flags || res[1].flags)) {
- res[0].start = res[0].end = res[0].flags = 0;
- res[1].start = res[1].end = res[1].flags = 0;
- first_bar = 0;
- last_bar = 1;
- }
-
- /* secondary channel: ProgIf bit 2, BAR2, BAR3 */
- if (!(dev->class & 4) && (res[2].flags || res[3].flags)) {
- res[2].start = res[2].end = res[2].flags = 0;
- res[3].start = res[3].end = res[3].flags = 0;
- last_bar = 3;
- }
-
- if (!last_bar)
- return;
-
- printk(KERN_INFO "PCI: Ignoring BAR%d-%d of IDE controller %s\n",
- first_bar, last_bar, pci_name(dev));
-}
-DECLARE_PCI_FIXUP_HEADER(PCI_ANY_ID, PCI_ANY_ID, quirk_ide_bases);
-
-/*
* Ensure C0 rev restreaming is off. This is normally done by
* the BIOS but in the odd case it is not the results are corruption
* hence the presence of a Linux check
@@ -880,11 +830,10 @@ static void __devinit quirk_svwks_csb5ide(struct pci_dev *pdev)
prog &= ~5;
pdev->class &= ~5;
pci_write_config_byte(pdev, PCI_CLASS_PROG, prog);
- /* need to re-assign BARs for compat mode */
- quirk_ide_bases(pdev);
+ /* PCI layer will sort out resources */
}
}
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5IDE, quirk_svwks_csb5ide );
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5IDE, quirk_svwks_csb5ide );
/*
* Intel 82801CAM ICH3-M datasheet says IDE modes must be the same
@@ -900,11 +849,9 @@ static void __init quirk_ide_samemode(struct pci_dev *pdev)
prog &= ~5;
pdev->class &= ~5;
pci_write_config_byte(pdev, PCI_CLASS_PROG, prog);
- /* need to re-assign BARs for compat mode */
- quirk_ide_bases(pdev);
}
}
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, quirk_ide_samemode);
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, quirk_ide_samemode);
/* This was originally an Alpha specific thing, but it really fits here.
* The i82375 PCI/EISA bridge appears as non-classified. Fix that.
generated by cgit v1.2.3 (git 2.25.1) at 2024-12-27 20:53:36 +0000