diff options
| -rw-r--r-- | drivers/usb/musb/cppi_dma.c | 33 |
1 files changed, 10 insertions, 23 deletions
diff --git a/drivers/usb/musb/cppi_dma.c b/drivers/usb/musb/cppi_dma.c index a44a450c860..3c69a76ec39 100644 --- a/drivers/usb/musb/cppi_dma.c +++ b/drivers/usb/musb/cppi_dma.c @@ -1191,8 +1191,13 @@ irqreturn_t cppi_interrupt(int irq, void *dev_id) bd = tx_ch->head; + /* + * If Head is null then this could mean that a abort interrupt + * that needs to be acknowledged. + */ if (NULL == bd) { DBG(1, "null BD\n"); + tx_ram->tx_complete = 0; continue; } @@ -1412,15 +1417,6 @@ static int cppi_channel_abort(struct dma_channel *channel) if (cppi_ch->transmit) { struct cppi_tx_stateram __iomem *tx_ram; - int enabled; - - /* mask interrupts raised to signal teardown complete. */ - enabled = musb_readl(tibase, DAVINCI_TXCPPI_INTENAB_REG) - & (1 << cppi_ch->index); - if (enabled) - musb_writel(tibase, DAVINCI_TXCPPI_INTCLR_REG, - (1 << cppi_ch->index)); - /* REVISIT put timeouts on these controller handshakes */ cppi_dump_tx(6, cppi_ch, " (teardown)"); @@ -1435,7 +1431,6 @@ static int cppi_channel_abort(struct dma_channel *channel) do { value = musb_readl(&tx_ram->tx_complete, 0); } while (0xFFFFFFFC != value); - musb_writel(&tx_ram->tx_complete, 0, 0xFFFFFFFC); /* FIXME clean up the transfer state ... here? * the completion routine should get called with @@ -1448,23 +1443,15 @@ static int cppi_channel_abort(struct dma_channel *channel) musb_writew(regs, MUSB_TXCSR, value); musb_writew(regs, MUSB_TXCSR, value); - /* While we scrub the TX state RAM, ensure that we clean - * up any interrupt that's currently asserted: + /* * 1. Write to completion Ptr value 0x1(bit 0 set) * (write back mode) - * 2. Write to completion Ptr value 0x0(bit 0 cleared) - * (compare mode) - * Value written is compared(for bits 31:2) and when - * equal, interrupt is deasserted. + * 2. Wait for abort interrupt and then put the channel in + * compare mode by writing 1 to the tx_complete register. */ cppi_reset_tx(tx_ram, 1); - musb_writel(&tx_ram->tx_complete, 0, 0); - - /* re-enable interrupt */ - if (enabled) - musb_writel(tibase, DAVINCI_TXCPPI_INTENAB_REG, - (1 << cppi_ch->index)); - + cppi_ch->head = 0; + musb_writel(&tx_ram->tx_complete, 0, 1); cppi_dump_tx(5, cppi_ch, " (done teardown)"); /* REVISIT tx side _should_ clean up the same way |