diff options
Diffstat (limited to 'Documentation/IPMI.txt')
| -rw-r--r-- | Documentation/IPMI.txt | 25 |
1 files changed, 15 insertions, 10 deletions
diff --git a/Documentation/IPMI.txt b/Documentation/IPMI.txt index 24dc3fcf159..bc38283379f 100644 --- a/Documentation/IPMI.txt +++ b/Documentation/IPMI.txt @@ -441,17 +441,20 @@ ACPI, and if none of those then a KCS device at the spec-specified 0xca2. If you want to turn this off, set the "trydefaults" option to false. -If you have high-res timers compiled into the kernel, the driver will -use them to provide much better performance. Note that if you do not -have high-res timers enabled in the kernel and you don't have -interrupts enabled, the driver will run VERY slowly. Don't blame me, +If your IPMI interface does not support interrupts and is a KCS or +SMIC interface, the IPMI driver will start a kernel thread for the +interface to help speed things up. This is a low-priority kernel +thread that constantly polls the IPMI driver while an IPMI operation +is in progress. The force_kipmid module parameter will all the user to +force this thread on or off. If you force it off and don't have +interrupts, the driver will run VERY slowly. Don't blame me, these interfaces suck. The driver supports a hot add and remove of interfaces. This way, interfaces can be added or removed after the kernel is up and running. -This is done using /sys/modules/ipmi_si/hotmod, which is a write-only -parameter. You write a string to this interface. The string has the -format: +This is done using /sys/modules/ipmi_si/parameters/hotmod, which is a +write-only parameter. You write a string to this interface. The string +has the format: <op1>[:op2[:op3...]] The "op"s are: add|remove,kcs|bt|smic,mem|i/o,<address>[,<opt1>[,<opt2>[,...]]] @@ -581,9 +584,11 @@ The watchdog will panic and start a 120 second reset timeout if it gets a pre-action. During a panic or a reboot, the watchdog will start a 120 timer if it is running to make sure the reboot occurs. -Note that if you use the NMI preaction for the watchdog, you MUST -NOT use nmi watchdog mode 1. If you use the NMI watchdog, you -must use mode 2. +Note that if you use the NMI preaction for the watchdog, you MUST NOT +use the nmi watchdog. There is no reasonable way to tell if an NMI +comes from the IPMI controller, so it must assume that if it gets an +otherwise unhandled NMI, it must be from IPMI and it will panic +immediately. Once you open the watchdog timer, you must write a 'V' character to the device to close it, or the timer will not stop. This is a new semantic |