diff options
Diffstat (limited to 'arch/arm/mach-pxa/include/mach/dma.h')
| -rw-r--r-- | arch/arm/mach-pxa/include/mach/dma.h | 56 |
1 files changed, 56 insertions, 0 deletions
diff --git a/arch/arm/mach-pxa/include/mach/dma.h b/arch/arm/mach-pxa/include/mach/dma.h index 77607fe4bd6..b0812f59d3f 100644 --- a/arch/arm/mach-pxa/include/mach/dma.h +++ b/arch/arm/mach-pxa/include/mach/dma.h @@ -12,6 +12,62 @@ #ifndef __ASM_ARCH_DMA_H #define __ASM_ARCH_DMA_H +#include <mach/hardware.h> + +/* DMA Controller Registers Definitions */ +#define DMAC_REGS_VIRT io_p2v(0x40000000) +#define DMAC_REG(x) (*((volatile u32 *)(DMAC_REGS_VIRT + (x)))) + +#define DCSR(n) DMAC_REG((n) << 2) +#define DALGN DMAC_REG(0x00a0) /* DMA Alignment Register */ +#define DINT DMAC_REG(0x00f0) /* DMA Interrupt Register */ +#define DDADR(n) DMAC_REG(0x0200 + ((n) << 4)) +#define DSADR(n) DMAC_REG(0x0204 + ((n) << 4)) +#define DTADR(n) DMAC_REG(0x0208 + ((n) << 4)) +#define DCMD(n) DMAC_REG(0x020c + ((n) << 4)) +#define DRCMR(n) DMAC_REG((((n) < 64) ? 0x0100 : 0x1100) + \ + (((n) & 0x3f) << 2)) + +#define DCSR_RUN (1 << 31) /* Run Bit (read / write) */ +#define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */ +#define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */ +#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */ +#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */ +#define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */ +#define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */ +#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */ + +#if defined(CONFIG_PXA27x) || defined(CONFIG_PXA3xx) +#define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */ +#define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */ +#define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */ +#define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */ +#define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */ +#define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */ +#define DCSR_EORINTR (1 << 9) /* The end of Receive */ +#endif + +#define DRCMR_MAPVLD (1 << 7) /* Map Valid (read / write) */ +#define DRCMR_CHLNUM 0x1f /* mask for Channel Number (read / write) */ + +#define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor (mask) */ +#define DDADR_STOP (1 << 0) /* Stop (read / write) */ + +#define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */ +#define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */ +#define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */ +#define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */ +#define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */ +#define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */ +#define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */ +#define DCMD_BURST8 (1 << 16) /* 8 byte burst */ +#define DCMD_BURST16 (2 << 16) /* 16 byte burst */ +#define DCMD_BURST32 (3 << 16) /* 32 byte burst */ +#define DCMD_WIDTH1 (1 << 14) /* 1 byte width */ +#define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */ +#define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */ +#define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */ + /* * Descriptor structure for PXA's DMA engine * Note: this structure must always be aligned to a 16-byte boundary. |