diff options
Diffstat (limited to 'drivers')
-rw-r--r-- | drivers/ata/sata_mv.c | 52 |
1 files changed, 28 insertions, 24 deletions
diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c index 146b8e67c44..3bfe721ba76 100644 --- a/drivers/ata/sata_mv.c +++ b/drivers/ata/sata_mv.c @@ -345,7 +345,7 @@ enum { EDMA_ARB_CFG_OFS = 0x38, EDMA_HALTCOND_OFS = 0x60, /* GenIIe halt conditions */ - + EDMA_UNKNOWN_RSVD_OFS = 0x6C, /* GenIIe unknown/reserved */ BMDMA_CMD_OFS = 0x224, /* bmdma command register */ BMDMA_STATUS_OFS = 0x228, /* bmdma status register */ @@ -447,6 +447,7 @@ struct mv_cached_regs { u32 fiscfg; u32 ltmode; u32 haltcond; + u32 unknown_rsvd; }; struct mv_port_priv { @@ -563,8 +564,6 @@ static void mv_pmp_error_handler(struct ata_port *ap); static void mv_process_crpb_entries(struct ata_port *ap, struct mv_port_priv *pp); -static unsigned long mv_mode_filter(struct ata_device *dev, - unsigned long xfer_mask); static void mv_sff_irq_clear(struct ata_port *ap); static int mv_check_atapi_dma(struct ata_queued_cmd *qc); static void mv_bmdma_setup(struct ata_queued_cmd *qc); @@ -626,7 +625,6 @@ static struct ata_port_operations mv6_ops = { .bmdma_start = mv_bmdma_start, .bmdma_stop = mv_bmdma_stop, .bmdma_status = mv_bmdma_status, - .mode_filter = mv_mode_filter, }; static struct ata_port_operations mv_iie_ops = { @@ -842,6 +840,7 @@ static void mv_save_cached_regs(struct ata_port *ap) pp->cached.fiscfg = readl(port_mmio + FISCFG_OFS); pp->cached.ltmode = readl(port_mmio + LTMODE_OFS); pp->cached.haltcond = readl(port_mmio + EDMA_HALTCOND_OFS); + pp->cached.unknown_rsvd = readl(port_mmio + EDMA_UNKNOWN_RSVD_OFS); } /** @@ -1252,6 +1251,30 @@ static void mv_60x1_errata_sata25(struct ata_port *ap, int want_ncq) writel(new, hpriv->base + MV_GPIO_PORT_CTL_OFS); } +/** + * mv_bmdma_enable - set a magic bit on GEN_IIE to allow bmdma + * @ap: Port being initialized + * + * There are two DMA modes on these chips: basic DMA, and EDMA. + * + * Bit-0 of the "EDMA RESERVED" register enables/disables use + * of basic DMA on the GEN_IIE versions of the chips. + * + * This bit survives EDMA resets, and must be set for basic DMA + * to function, and should be cleared when EDMA is active. + */ +static void mv_bmdma_enable_iie(struct ata_port *ap, int enable_bmdma) +{ + struct mv_port_priv *pp = ap->private_data; + u32 new, *old = &pp->cached.unknown_rsvd; + + if (enable_bmdma) + new = *old | 1; + else + new = *old & ~1; + mv_write_cached_reg(mv_ap_base(ap) + EDMA_UNKNOWN_RSVD_OFS, old, new); +} + static void mv_edma_cfg(struct ata_port *ap, int want_ncq, int want_edma) { u32 cfg; @@ -1297,6 +1320,7 @@ static void mv_edma_cfg(struct ata_port *ap, int want_ncq, int want_edma) } if (hpriv->hp_flags & MV_HP_CUT_THROUGH) cfg |= (1 << 17); /* enab cut-thru (dis stor&forwrd) */ + mv_bmdma_enable_iie(ap, !want_edma); } if (want_ncq) { @@ -1465,26 +1489,6 @@ static void mv_crqb_pack_cmd(__le16 *cmdw, u8 data, u8 addr, unsigned last) } /** - * mv_mode_filter - Allow ATAPI DMA only on GenII chips. - * @dev: device whose xfer modes are being configured. - * - * Only the GenII hardware can use DMA with ATAPI drives. - */ -static unsigned long mv_mode_filter(struct ata_device *adev, - unsigned long xfer_mask) -{ - if (adev->class == ATA_DEV_ATAPI) { - struct mv_host_priv *hpriv = adev->link->ap->host->private_data; - if (!IS_GEN_II(hpriv)) { - xfer_mask &= ~(ATA_MASK_MWDMA | ATA_MASK_UDMA); - ata_dev_printk(adev, KERN_INFO, - "ATAPI DMA not supported on this chipset\n"); - } - } - return xfer_mask; -} - -/** * mv_sff_irq_clear - Clear hardware interrupt after DMA. * @ap: Port associated with this ATA transaction. * |