diff options
Diffstat (limited to 'net/mac80211/rc80211_pid_algo.c')
-rw-r--r-- | net/mac80211/rc80211_pid_algo.c | 86 |
1 files changed, 45 insertions, 41 deletions
diff --git a/net/mac80211/rc80211_pid_algo.c b/net/mac80211/rc80211_pid_algo.c index 3b77410588e..9762803e487 100644 --- a/net/mac80211/rc80211_pid_algo.c +++ b/net/mac80211/rc80211_pid_algo.c @@ -63,6 +63,7 @@ * RC_PID_ARITH_SHIFT. */ + /* Adjust the rate while ensuring that we won't switch to a lower rate if it * exhibited a worse failed frames behaviour and we'll choose the highest rate * whose failed frames behaviour is not worse than the one of the original rate @@ -72,14 +73,14 @@ static void rate_control_pid_adjust_rate(struct ieee80211_local *local, struct rc_pid_rateinfo *rinfo) { struct ieee80211_sub_if_data *sdata; - struct ieee80211_hw_mode *mode; - int cur_sorted, new_sorted, probe, tmp, n_bitrates; - int cur = sta->txrate; + struct ieee80211_supported_band *sband; + int cur_sorted, new_sorted, probe, tmp, n_bitrates, band; + int cur = sta->txrate_idx; sdata = IEEE80211_DEV_TO_SUB_IF(sta->dev); - - mode = local->oper_hw_mode; - n_bitrates = mode->num_rates; + sband = local->hw.wiphy->bands[local->hw.conf.channel->band]; + band = sband->band; + n_bitrates = sband->n_bitrates; /* Map passed arguments to sorted values. */ cur_sorted = rinfo[cur].rev_index; @@ -97,20 +98,20 @@ static void rate_control_pid_adjust_rate(struct ieee80211_local *local, /* Ensure that the rate decrease isn't disadvantageous. */ for (probe = cur_sorted; probe >= new_sorted; probe--) if (rinfo[probe].diff <= rinfo[cur_sorted].diff && - rate_supported(sta, mode, rinfo[probe].index)) + rate_supported(sta, band, rinfo[probe].index)) tmp = probe; } else { /* Look for rate increase with zero (or below) cost. */ for (probe = new_sorted + 1; probe < n_bitrates; probe++) if (rinfo[probe].diff <= rinfo[new_sorted].diff && - rate_supported(sta, mode, rinfo[probe].index)) + rate_supported(sta, band, rinfo[probe].index)) tmp = probe; } /* Fit the rate found to the nearest supported rate. */ do { - if (rate_supported(sta, mode, rinfo[tmp].index)) { - sta->txrate = rinfo[tmp].index; + if (rate_supported(sta, band, rinfo[tmp].index)) { + sta->txrate_idx = rinfo[tmp].index; break; } if (adj < 0) @@ -122,7 +123,7 @@ static void rate_control_pid_adjust_rate(struct ieee80211_local *local, #ifdef CONFIG_MAC80211_DEBUGFS rate_control_pid_event_rate_change( &((struct rc_pid_sta_info *)sta->rate_ctrl_priv)->events, - cur, mode->rates[cur].rate); + sta->txrate_idx, sband->bitrates[sta->txrate_idx].bitrate); #endif } @@ -149,7 +150,7 @@ static void rate_control_pid_sample(struct rc_pid_info *pinfo, { struct rc_pid_sta_info *spinfo = sta->rate_ctrl_priv; struct rc_pid_rateinfo *rinfo = pinfo->rinfo; - struct ieee80211_hw_mode *mode; + struct ieee80211_supported_band *sband; u32 pf; s32 err_avg; u32 err_prop; @@ -158,7 +159,7 @@ static void rate_control_pid_sample(struct rc_pid_info *pinfo, int adj, i, j, tmp; unsigned long period; - mode = local->oper_hw_mode; + sband = local->hw.wiphy->bands[local->hw.conf.channel->band]; spinfo = sta->rate_ctrl_priv; /* In case nothing happened during the previous control interval, turn @@ -184,18 +185,18 @@ static void rate_control_pid_sample(struct rc_pid_info *pinfo, spinfo->tx_num_failed = 0; /* If we just switched rate, update the rate behaviour info. */ - if (pinfo->oldrate != sta->txrate) { + if (pinfo->oldrate != sta->txrate_idx) { i = rinfo[pinfo->oldrate].rev_index; - j = rinfo[sta->txrate].rev_index; + j = rinfo[sta->txrate_idx].rev_index; tmp = (pf - spinfo->last_pf); tmp = RC_PID_DO_ARITH_RIGHT_SHIFT(tmp, RC_PID_ARITH_SHIFT); rinfo[j].diff = rinfo[i].diff + tmp; - pinfo->oldrate = sta->txrate; + pinfo->oldrate = sta->txrate_idx; } - rate_control_pid_normalize(pinfo, mode->num_rates); + rate_control_pid_normalize(pinfo, sband->n_bitrates); /* Compute the proportional, integral and derivative errors. */ err_prop = (pinfo->target << RC_PID_ARITH_SHIFT) - pf; @@ -236,8 +237,10 @@ static void rate_control_pid_tx_status(void *priv, struct net_device *dev, struct sta_info *sta; struct rc_pid_sta_info *spinfo; unsigned long period; + struct ieee80211_supported_band *sband; sta = sta_info_get(local, hdr->addr1); + sband = local->hw.wiphy->bands[local->hw.conf.channel->band]; if (!sta) return; @@ -245,13 +248,13 @@ static void rate_control_pid_tx_status(void *priv, struct net_device *dev, /* Don't update the state if we're not controlling the rate. */ sdata = IEEE80211_DEV_TO_SUB_IF(sta->dev); if (sdata->bss && sdata->bss->force_unicast_rateidx > -1) { - sta->txrate = sdata->bss->max_ratectrl_rateidx; + sta->txrate_idx = sdata->bss->max_ratectrl_rateidx; return; } /* Ignore all frames that were sent with a different rate than the rate * we currently advise mac80211 to use. */ - if (status->control.rate != &local->oper_hw_mode->rates[sta->txrate]) + if (status->control.tx_rate != &sband->bitrates[sta->txrate_idx]) goto ignore; spinfo = sta->rate_ctrl_priv; @@ -277,9 +280,6 @@ static void rate_control_pid_tx_status(void *priv, struct net_device *dev, sta->tx_num_consecutive_failures++; sta->tx_num_mpdu_fail++; } else { - sta->last_ack_rssi[0] = sta->last_ack_rssi[1]; - sta->last_ack_rssi[1] = sta->last_ack_rssi[2]; - sta->last_ack_rssi[2] = status->ack_signal; sta->tx_num_consecutive_failures = 0; sta->tx_num_mpdu_ok++; } @@ -298,7 +298,7 @@ ignore: } static void rate_control_pid_get_rate(void *priv, struct net_device *dev, - struct ieee80211_hw_mode *mode, + struct ieee80211_supported_band *sband, struct sk_buff *skb, struct rate_selection *sel) { @@ -316,7 +316,7 @@ static void rate_control_pid_get_rate(void *priv, struct net_device *dev, fc = le16_to_cpu(hdr->frame_control); if ((fc & IEEE80211_FCTL_FTYPE) != IEEE80211_FTYPE_DATA || is_multicast_ether_addr(hdr->addr1) || !sta) { - sel->rate = rate_lowest(local, mode, sta); + sel->rate = rate_lowest(local, sband, sta); if (sta) sta_info_put(sta); return; @@ -325,23 +325,23 @@ static void rate_control_pid_get_rate(void *priv, struct net_device *dev, /* If a forced rate is in effect, select it. */ sdata = IEEE80211_DEV_TO_SUB_IF(dev); if (sdata->bss && sdata->bss->force_unicast_rateidx > -1) - sta->txrate = sdata->bss->force_unicast_rateidx; + sta->txrate_idx = sdata->bss->force_unicast_rateidx; - rateidx = sta->txrate; + rateidx = sta->txrate_idx; - if (rateidx >= mode->num_rates) - rateidx = mode->num_rates - 1; + if (rateidx >= sband->n_bitrates) + rateidx = sband->n_bitrates - 1; - sta->last_txrate = rateidx; + sta->last_txrate_idx = rateidx; sta_info_put(sta); - sel->rate = &mode->rates[rateidx]; + sel->rate = &sband->bitrates[rateidx]; #ifdef CONFIG_MAC80211_DEBUGFS rate_control_pid_event_tx_rate( &((struct rc_pid_sta_info *) sta->rate_ctrl_priv)->events, - rateidx, mode->rates[rateidx].rate); + rateidx, sband->bitrates[rateidx].bitrate); #endif } @@ -353,28 +353,32 @@ static void rate_control_pid_rate_init(void *priv, void *priv_sta, * as we need to have IEEE 802.1X auth succeed immediately after assoc.. * Until that method is implemented, we will use the lowest supported * rate as a workaround. */ - sta->txrate = rate_lowest_index(local, local->oper_hw_mode, sta); + struct ieee80211_supported_band *sband; + + sband = local->hw.wiphy->bands[local->hw.conf.channel->band]; + sta->txrate_idx = rate_lowest_index(local, sband, sta); } static void *rate_control_pid_alloc(struct ieee80211_local *local) { struct rc_pid_info *pinfo; struct rc_pid_rateinfo *rinfo; - struct ieee80211_hw_mode *mode; + struct ieee80211_supported_band *sband; int i, j, tmp; bool s; #ifdef CONFIG_MAC80211_DEBUGFS struct rc_pid_debugfs_entries *de; #endif + sband = local->hw.wiphy->bands[local->hw.conf.channel->band]; + pinfo = kmalloc(sizeof(*pinfo), GFP_ATOMIC); if (!pinfo) return NULL; - /* We can safely assume that oper_hw_mode won't change unless we get + /* We can safely assume that sband won't change unless we get * reinitialized. */ - mode = local->oper_hw_mode; - rinfo = kmalloc(sizeof(*rinfo) * mode->num_rates, GFP_ATOMIC); + rinfo = kmalloc(sizeof(*rinfo) * sband->n_bitrates, GFP_ATOMIC); if (!rinfo) { kfree(pinfo); return NULL; @@ -383,7 +387,7 @@ static void *rate_control_pid_alloc(struct ieee80211_local *local) /* Sort the rates. This is optimized for the most common case (i.e. * almost-sorted CCK+OFDM rates). Kind of bubble-sort with reversed * mapping too. */ - for (i = 0; i < mode->num_rates; i++) { + for (i = 0; i < sband->n_bitrates; i++) { rinfo[i].index = i; rinfo[i].rev_index = i; if (pinfo->fast_start) @@ -391,11 +395,11 @@ static void *rate_control_pid_alloc(struct ieee80211_local *local) else rinfo[i].diff = i * pinfo->norm_offset; } - for (i = 1; i < mode->num_rates; i++) { + for (i = 1; i < sband->n_bitrates; i++) { s = 0; - for (j = 0; j < mode->num_rates - i; j++) - if (unlikely(mode->rates[rinfo[j].index].rate > - mode->rates[rinfo[j + 1].index].rate)) { + for (j = 0; j < sband->n_bitrates - i; j++) + if (unlikely(sband->bitrates[rinfo[j].index].bitrate > + sband->bitrates[rinfo[j + 1].index].bitrate)) { tmp = rinfo[j].index; rinfo[j].index = rinfo[j + 1].index; rinfo[j + 1].index = tmp; |