aboutsummaryrefslogtreecommitdiff
path: root/drivers/net
AgeCommit message (Expand)Author
2008-11-06ehea: Fix some whitespace issuesHannes Hering
2008-11-06sfc: Do not reset when hardware monitor detects a faultBen Hutchings
2008-11-06sfc: Use lm87 and lm90 drivers for board temperature/power monitoringBen Hutchings
2008-11-06sfc: Expose flash region storing boot code as MTDBen Hutchings
2008-11-06sfc: Clean up non-volatile memory partitioningBen Hutchings
2008-11-06sfc: Correct address of gPXE boot configuration in EEPROMBen Hutchings
2008-11-06bonding: alternate agg selection policies for 802.3adJay Vosburgh
2008-11-06bonding: Fix ALB mode to balance traffic on VLANsJay Vosburgh
2008-11-06bonding: send IPv6 neighbor advertisement on failoverBrian Haley
2008-11-05net: Guaranetee the proper ordering of the loopback device.Eric W. Biederman
2008-11-03drivers/net: Kill now superfluous ->last_rx stores.David S. Miller
2008-11-03bonding, net: Move last_rx update into bonding recv logicJay Vosburgh
2008-11-03tg3: Update version to 3.95Matt Carlson
2008-11-03broadcom: Add support for BCM50610Matt Carlson
2008-11-03broadcom: Refine expansion register access routineMatt Carlson
2008-11-03broadcom: Add flow control supportMatt Carlson
2008-11-03tg3: 5785 enhancementsMatt Carlson
2008-11-03tg3: Refine phylib supportMatt Carlson
2008-11-03tg3: Allow WOL for phylib controlled Broadcom physMatt Carlson
2008-11-03tg3: Refine power management and WOL codeMatt Carlson
2008-11-03tg3: Move phylib report to end of tg3_init_oneMatt Carlson
2008-11-03tg3: Do not enable APE on bcm5700Matt Carlson
2008-11-03tg3: Reclaim TG3_FLG3_5761_5784_AX_FIXES flagMatt Carlson
2008-11-03tg3: Preserve LAA when device control is releasedMatt Carlson
2008-11-03tg3: Preserve DASH connectivity when WOL enabledMatt Carlson
2008-11-03tg3: Use pci_ioremap_bar()Matt Carlson
2008-11-03tg3: Add 5761S supportMatt Carlson
2008-11-02smc91x: add __init markings to smc_drv_probe()Mike Frysinger
2008-11-02forcdeth: increase max_interrupt_workJoe Korty
2008-11-02ixgbe: add device support for 82598AT (copper 10GbE) adaptersJesse Brandeburg
2008-11-02atlx: timer cleanupStephen Hemminger
2008-11-02atlx: use embedded net_device_statsStephen Hemminger
2008-10-31ath9k: use ETH_P_PAELuis R. Rodriguez
2008-10-31ath9k: remove useless conditionalBob Copeland
2008-10-31orinoco: cache downloadable firmware image in memory for use during resumeAndrey Borzenkov
2008-10-31orinoco: reload firmware on resumeAndrey Borzenkov
2008-10-31ath5k: Update interrupt masking codeNick Kossifidis
2008-10-31wireless: remove struct regdom hintingJohannes Berg
2008-10-31iwlwifi: Update reclaim flagDaniel Halperin
2008-10-31iwl3945: iwl3945_mac_get_tsf() should not return zeroFabrice Bellet
2008-10-31iwlwifi: run through spell checkerTomas Winkler
2008-10-31iwlwifi: refactor tx byte count table usageTomas Winkler
2008-10-31iwlwifi: clear scanning bits upon failureMohamed Abbas
2008-10-31iwlwifi: convert correctly rate_n_flags to PLCP index for mimo3 packetsDaniel C. Halperin
2008-10-31iwlwifi: calibration command namespace renamingTomas Winkler
2008-10-31iwlwifi: parametrize eeprom versionsTomas Winkler
2008-10-31iwlwifi: don't update TFD free counter for invalid stationTomas Winkler
2008-10-31iwlwifi: refactor TX response flowTomas Winkler
2008-10-31mac80211: Re-enable aggregationSujith
2008-10-31ath9k: Check if the STA supports HT when initializing rate controlSujith
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-15 06:34:49 +0000