diff options
-rw-r--r-- | include/net/mac80211.h | 19 | ||||
-rw-r--r-- | net/mac80211/mlme.c | 20 |
2 files changed, 32 insertions, 7 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 183956e4930..446dbf75a1c 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -517,7 +517,7 @@ struct ieee80211_rx_status { * Flags to define PHY configuration options * * @IEEE80211_CONF_RADIOTAP: add radiotap header at receive time (if supported) - * @IEEE80211_CONF_PS: Enable 802.11 power save mode + * @IEEE80211_CONF_PS: Enable 802.11 power save mode (managed mode only) */ enum ieee80211_conf_flags { IEEE80211_CONF_RADIOTAP = (1<<0), @@ -553,14 +553,26 @@ enum ieee80211_conf_changed { * * This struct indicates how the driver shall configure the hardware. * + * @flags: configuration flags defined above + * * @radio_enabled: when zero, driver is required to switch off the radio. * @beacon_int: beacon interval (TODO make interface config) + * * @listen_interval: listen interval in units of beacon interval - * @flags: configuration flags defined above + * @max_sleep_interval: the maximum number of beacon intervals to sleep for + * before checking the beacon for a TIM bit (managed mode only); this + * value will be only achievable between DTIM frames, the hardware + * needs to check for the multicast traffic bit in DTIM beacons. + * This variable is valid only when the CONF_PS flag is set. + * @dynamic_ps_timeout: The dynamic powersave timeout (in ms), see the + * powersave documentation below. This variable is valid only when + * the CONF_PS flag is set. + * * @power_level: requested transmit power (in dBm) - * @dynamic_ps_timeout: dynamic powersave timeout (in ms) + * * @channel: the channel to tune to * @channel_type: the channel (HT) type + * * @long_frame_max_tx_count: Maximum number of transmissions for a "long" frame * (a frame not RTS protected), called "dot11LongRetryLimit" in 802.11, * but actually means the number of transmissions not the number of retries @@ -572,6 +584,7 @@ struct ieee80211_conf { int beacon_int; u32 flags; int power_level, dynamic_ps_timeout; + int max_sleep_interval; u16 listen_interval; bool radio_enabled; diff --git a/net/mac80211/mlme.c b/net/mac80211/mlme.c index e819c02d13f..df27c68620c 100644 --- a/net/mac80211/mlme.c +++ b/net/mac80211/mlme.c @@ -545,10 +545,19 @@ void ieee80211_recalc_ps(struct ieee80211_local *local, s32 latency) beaconint_us = ieee80211_tu_to_usec( found->vif.bss_conf.beacon_int); - if (beaconint_us > latency) + if (beaconint_us > latency) { local->ps_sdata = NULL; - else + } else { + u8 dtimper = found->vif.bss_conf.dtim_period; + int maxslp = 1; + + if (dtimper > 1) + maxslp = min_t(int, dtimper, + latency / beaconint_us); + + local->hw.conf.max_sleep_interval = maxslp; local->ps_sdata = found; + } } else { local->ps_sdata = NULL; } @@ -851,8 +860,11 @@ static void ieee80211_set_associated(struct ieee80211_sub_if_data *sdata, ieee80211_bss_info_change_notify(sdata, bss_info_changed); /* will be same as sdata */ - if (local->ps_sdata) - ieee80211_enable_ps(local, sdata); + if (local->ps_sdata) { + mutex_lock(&local->iflist_mtx); + ieee80211_recalc_ps(local, -1); + mutex_unlock(&local->iflist_mtx); + } netif_tx_start_all_queues(sdata->dev); netif_carrier_on(sdata->dev); |