1 files changed, 0 insertions, 101 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-4965.c b/drivers/net/wireless/iwlwifi/iwl-4965.c
index 44215a7ab0a..aeaf5f78997 100644
--- a/drivers/net/wireless/iwlwifi/iwl-4965.c
+++ b/drivers/net/wireless/iwlwifi/iwl-4965.c
@@ -3433,109 +3433,8 @@ static int iwl4965_tx_queue_agg_enable(struct iwl_priv *priv, int txq_id,
 
 #endif /* CONFIG_IWL4965_HT */
 
-/**
- * iwl4965_add_station - Initialize a station's hardware rate table
- *
- * The uCode's station table contains a table of fallback rates
- * for automatic fallback during transmission.
- *
- * NOTE: This sets up a default set of values.  These will be replaced later
- *       if the driver's iwl-4965-rs rate scaling algorithm is used, instead of
- *       rc80211_simple.
- *
- * NOTE: Run REPLY_ADD_STA command to set up station table entry, before
- *       calling this function (which runs REPLY_TX_LINK_QUALITY_CMD,
- *       which requires station table entry to exist).
- */
-void iwl4965_add_station(struct iwl_priv *priv, const u8 *addr, int is_ap)
-{
-	int i, r;
-	struct iwl_link_quality_cmd link_cmd = {
-		.reserved1 = 0,
-	};
-	u16 rate_flags;
-
-	/* Set up the rate scaling to start at selected rate, fall back
-	 * all the way down to 1M in IEEE order, and then spin on 1M */
-	if (is_ap)
-		r = IWL_RATE_54M_INDEX;
-	else if (priv->band == IEEE80211_BAND_5GHZ)
-		r = IWL_RATE_6M_INDEX;
-	else
-		r = IWL_RATE_1M_INDEX;
-
-	for (i = 0; i < LINK_QUAL_MAX_RETRY_NUM; i++) {
-		rate_flags = 0;
-		if (r >= IWL_FIRST_CCK_RATE && r <= IWL_LAST_CCK_RATE)
-			rate_flags |= RATE_MCS_CCK_MSK;
-
-		/* Use Tx antenna B only */
-		rate_flags |= RATE_MCS_ANT_B_MSK; /*FIXME:RS*/
-
-		link_cmd.rs_table[i].rate_n_flags =
-			iwl4965_hw_set_rate_n_flags(iwl_rates[r].plcp, rate_flags);
-		r = iwl4965_get_prev_ieee_rate(r);
-	}
-
-	link_cmd.general_params.single_stream_ant_msk = 2;
-	link_cmd.general_params.dual_stream_ant_msk = 3;
-	link_cmd.agg_params.agg_dis_start_th = 3;
-	link_cmd.agg_params.agg_time_limit = cpu_to_le16(4000);
-
-	/* Update the rate scaling for control frame Tx to AP */
-	link_cmd.sta_id = is_ap ? IWL_AP_ID : priv->hw_params.bcast_sta_id;
-
-	iwl_send_cmd_pdu_async(priv, REPLY_TX_LINK_QUALITY_CMD,
-			       sizeof(link_cmd), &link_cmd, NULL);
-}
 
 #ifdef CONFIG_IWL4965_HT
-
-void iwl4965_set_ht_add_station(struct iwl_priv *priv, u8 index,
-				struct ieee80211_ht_info *sta_ht_inf)
-{
-	__le32 sta_flags;
-	u8 mimo_ps_mode;
-
-	if (!sta_ht_inf || !sta_ht_inf->ht_supported)
-		goto done;
-
-	mimo_ps_mode = (sta_ht_inf->cap & IEEE80211_HT_CAP_MIMO_PS) >> 2;
-
-	sta_flags = priv->stations[index].sta.station_flags;
-
-	sta_flags &= ~(STA_FLG_RTS_MIMO_PROT_MSK | STA_FLG_MIMO_DIS_MSK);
-
-	switch (mimo_ps_mode) {
-	case WLAN_HT_CAP_MIMO_PS_STATIC:
-		sta_flags |= STA_FLG_MIMO_DIS_MSK;
-		break;
-	case WLAN_HT_CAP_MIMO_PS_DYNAMIC:
-		sta_flags |= STA_FLG_RTS_MIMO_PROT_MSK;
-		break;
-	case WLAN_HT_CAP_MIMO_PS_DISABLED:
-		break;
-	default:
-		IWL_WARNING("Invalid MIMO PS mode %d", mimo_ps_mode);
-		break;
-	}
-
-	sta_flags |= cpu_to_le32(
-	      (u32)sta_ht_inf->ampdu_factor << STA_FLG_MAX_AGG_SIZE_POS);
-
-	sta_flags |= cpu_to_le32(
-	      (u32)sta_ht_inf->ampdu_density << STA_FLG_AGG_MPDU_DENSITY_POS);
-
-	if (iwl_is_fat_tx_allowed(priv, sta_ht_inf))
-		sta_flags |= STA_FLG_FAT_EN_MSK;
-	else
-		sta_flags &= ~STA_FLG_FAT_EN_MSK;
-
-	priv->stations[index].sta.station_flags = sta_flags;
- done:
-	return;
-}
-
 static int iwl4965_rx_agg_start(struct iwl_priv *priv,
 				const u8 *addr, int tid, u16 ssn)
 {